RIP and OSPF Redistribution

www.net130.com     日期:2005-6-21    浏览次数:
出处:Cisco网站

RIP and OSPF Redistribution

This case study addresses the issue of integrating Routing Information Protocol (RIP) networks with Open Shortest Path First (OSPF) networks. Most OSPF networks also use RIP to communicate with hosts or to communicate with portions of the internetwork that do not use OSPF. Cisco supports both the RIP and OSPF protocols and provides a way to exchange routing information between RIP and OSPF networks. This case study provides examples of how to complete the following phases in redistributing information between RIP and OSPF networks, including the following topics:

  • Configuring a RIP Network

  • Adding OSPF to the Center of a RIP Network

  • Adding OSPF Areas

  • Setting Up Mutual Redistribution

Configuring a RIP Network

Figure 14-1 illustrates a RIP network. Three sites are connected with serial lines. The RIP network uses a Class B address and an 8-bit subnet mask. Each site has a contiguous set of network numbers.


Figure 14-1:
A RIP network.


Table 14-1 lists the network address assignments for the RIP network, including the network number, subnet range, and subnet masks. All interfaces indicate network 130.10.0.0; however, the specific address includes the subnet and subnet mask. For example, serial interface 0 on Router C has an IP address of 130.10.63.3 with a subnet mask of 255.255.255.0.


Table 14-1: RIP Network Address Assignments
Network Number Subnets Subnet Masks

130.10.0.0

Site A: 8 through 15

255.255.255.0

130.10.0.0

Site B: 16 through 23

255.255.255.0

130.10.0.0

Site C: 24 through 31

255.255.255.0

130.10.0.0

Serial Backbone: 62 through 64

255.255.255.0

Configuration File Examples

The following commands in the configuration file for Router A determine the IP address for each interface and enable RIP on those interfaces:

interface serial 0
ip address 130.10.62.1 255.255.255.0
interface serial 1
ip address 130.10.63.1 255.255.255.0
interface ethernet 0
ip address 130.10.8.1 255.255.255.0
interface tokenring 0
ip address 130.10.9.1 255.255.255.0
router rip
network 130.10.0.0

The following commands in the configuration file for Router B determine the IP address for each interface and enable RIP on those interfaces:

interface serial 0
ip address 130.10.62.2 255.255.255.0
interface serial 1
ip address 130.10.64.2 255.255.255.0
interface ethernet 0
ip address 130.10.17.2 255.255.255.0
interface tokenring 0
ip address 130.10.16.2 255.255.255.0
router rip
network 130.10.0.0

The following commands in the configuration file for Router C determine the IP address for each interface and enable RIP on those interfaces:

interface serial 0
ip address 130.10.63.3 255.255.255.0
interface serial 1
ip address 130.10.64.3 255.255.255.0
interface ethernet 0
ip address 130.10.24.3 255.255.255.0
router rip
network 130.10.0.0

本新闻共4页,当前在第1页  1  2  3  4  

相关新闻
无相关正文