|
描述：合并两个FLASH成一个，例如路由器上插有两个8M的FLASH，在屏幕显示是一个16M的FLASH。
Router#show version
Processor board ID JAD06100CD1 (1588947843)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.2 Ethernet/IEEE 802.3 interface(s)
32K bytes of non-volatile configuration memory.
8084K bytes of processor board System flash (Read/Write)
8084K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
1、首先在路由器上显示一下FLASH的情况：
Router#dir flash?
Flash:1:
Flash:2:
2、把flash:2:删除
Router#erase flash:2:
3、合并两个flash
Router(config)#partition flash 1 /把两个 FLASH合并成一个FLASH1
Router#write memory
修改完后会显示这样的信息：
Router#show version
Processor board ID JAD06100CD1 (1588947843)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0. 2 Ethernet/IEEE 802.3 interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102[/U]
|